You are here:Home/Temporary Flood Barriers for Homes
The Homebarrier has been specially developed for relatively small floods and flooding. The Homebarrier can turn up to 40 cm of water. The temporary flood defense consists of a tunnel with a flap on it. The front of the flap must be anchored to the surface by means of a metal profile that is slid onto the front flap and anchored to the ground with the help of bolts. This means that the water cannot flow under the temporary flood defense.
The flood water runs on the flap and flows into the tunnel through the filling openings located at the bottom of the tunnel. The rear of the tunnel is closed. The water in the tunnel is just as high as the water from the flood. Because of the pressure, the weight of the water, the Homebarrier is pressed firmly to the ground. Compare it with a children’s pool in your garden, you empty a bucket of water in the bath and you can no longer move it.
Measuring the barrier is not difficult. First you must determine the location where the Homebarrier should be located. For example, as high as possible on the exit (street side) of your underground garage, or so that there are no obstacles present, the surface lends itself perfectly for it, etc. Be aware that the side of the tunnel of the Homebarrier is completely against a wall must stand (so the wall there must be at least 40 cm high). Measure the space between the two walls at this location. This is the size that you must enter in the order form.
When you have purchased the Homebarrier, you have a ready-made do-it-yourself package at home. We always advise you to do the first installation (once) as quickly as possible.
Pull the barrier into place
Slide the base plates onto the front flap and sides of the Barrier
If required, cut the base plates to size (note that they must be tight, so no cracks)
Drill a hole in the ground (preferably every 25 cm) (through the slot in the base plate)
Push the sleeve plugs into the hole and tighten them correctly
Test if everything fits properly
Clean up everything in the package and tighten the bolts in the plugs
You are now ready and will not soon be faced with surprises when there is a risk of flooding. In the event of an emergency, remove the barrier from the package and slide the base plates onto the front of the barrier. All you have to do now is to loosen the bolts from the ground and tighten the slots in the base plates and the Barrier is ready for use.
Click on the image below to start the quotation module, or click HERE
No more flooding !!
Also ready with (potential) flooding or need not wait for the government or municipality? Order now your own temporary flood defense for the private sector, va. € 200 per meter. This price for the 40 cm high Homebarrier includes fixation materials and sturdy storagebag.
For which situation?
In principle we have a solution for every situation, with some exceptions. Due to the temporary nature of the Homebarrier, it is eminently suitable in which a flood barrier must be installed quickly and temporarily to prevent or limit flooding.
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.